Monday, December 2, 2024
nanotrun.com
HomeAnswerMechanical properties of Molybdenum disulfide

Mechanical properties of Molybdenum disulfide

MoS2 excels as a lubricating material (see below) due to its layered structure and low coefficient of friction. Interlayer sliding dissipates energy when shear stress is applied to the material. Extensive work has been performed to characterize the coefficient of friction and shear strength of MoS2 in various atmospheres. The shear strength of MoS2 increases as the coefficient of friction increases. This property is called superlubricity. At ambient conditions, the coefficient of friction for MoS2 was determined to be 0.150, with a corresponding estimated shear strength of 56.0 MPa (megapascals). Direct methods of measuring the shear strength indicate that the value is closer to 25.3 MPa. The wear resistance of MoS2 in lubricating applications can be increased by doping MoS2 with Cr. Microindentation experiments on nanopillars of Cr-doped MoS2 found that the yield strength increased from an average of 821 MPa for pure MoS2 (at 0% Cr) to 1017 MPa at 50% Cr. A change in the material's failure mode accompanies the yield strength increase. While the pure MoS2 nanopillar fails through a plastic bending mechanism, brittle fracture modes become apparent as the material is loaded with increasing amounts of dopant. The widely used method of micromechanical exfoliation has been carefully studied in MoS2 to understand the mechanism of delamination in few-layer to multi-layer flakes. The exact mechanism of cleavage was found to be layer dependent. Flakes thinner than five layers undergo homogenous bending and rippling, while flakes around ten layers thick are delaminated through interlayer sliding. Flakes with more than 20 layers exhibited a kinking mechanism during micromechanical cleavage. The cleavage of these flakes was also determined to be reversible due to the nature of van der Waals bonding. In recent years, MoS2 has been utilized in flexible electronic applications, promoting more investigation into the elastic properties of this material. Nanoscopic bending tests using AFM cantilever tips were performed on micromechanically exfoliated MoS2 flakes deposited on a holey substrate. The yield strength of monolayer flakes was 270 GPa, while the thicker flakes were also stiffer, with a yield strength of 330 GPa. Molecular dynamic simulations found the in-plane yield strength of MoS2 to be 229 GPa, which matches the experimental results within error. If you are looking for high quality, high purity, and cost-effective Molybdenum disulfide, or if you require the latest price of Molybdenum disulfide, please feel free to email contact mis-asia.

RELATED ARTICLES
- Advertisment -spot_img

Most Popular

Recent Comments