Thursday, April 18, 2024
HomeAnswerTR6 Mini Foam Generator for CLC Blocks

TR6 Mini Foam Generator for CLC Blocks

<p>Oil futures tumbled more than $5 a barrel on news that the Biden administration is considering releasing about 1 million barrels a day from the U.S. Strategic Petroleum Reserve (SPR) for several months to cool surging crude prices.</p><p>Brent crude futures were down $4.71, or 4.2 percent, at $108.58 a barrel by 0035 GMT. U.S. West Texas Intermediate futures fell $5.45, or 5 percent, to $102.74 a barrel.</p><p>At an earlier time, gasoline prices had already reached record levels because of the Russia-Ukraine conflict.</p><p>The prices of other commodities like the Foam Generator are also expected to be volatile.</p>

Overview of TR6 CLC Foam Generator: 

Foam Concrete Machine is the core equipment of foam concrete production, which has a significant impact on the quality of foam concrete. An excellent foam generator for concrete not only has a high foam output but more importantly, the quality of the foam produced is outstanding. TR6 portable foam generator developed by our company. It can be used in laboratories, small-scale foam concrete cast-in-situ projects, and pilot lines of foam concrete products. The outstanding advantages of TR6 portable foam generator are low foam moisture content, more foaming agent, high foam uniformity, large foam output, and other benefits.

Data of TR6 CLC Foam Generator: 

Model TR6
Maximum foam output(m3/h) 6
Motor voltage(V) 220
Work rate(W) 610
Pressure(Mpa) 0.8
Pump suction(m) 1
Dimensions(cm) 600*400*400
Weight(kg) 20

Usually need to be disassembled:

1. After working for a long time, it is found that the foam shape is not good, usually more than three months.

2. Pipe blockage: Some foaming agent remaining in the bubble tube will form a solid residue. In this case, the foam cannot be produced normally, or the pipeline pressure increases sharply. At this time, all the old steel balls need to be taken out, and then replaced with a new one The ball is fine. Steel wire ball specification requirements: each blowing tube needs to be filled with about 12-15 steel wire balls. Too much or too little will affect or even destroy the foam performance.



1. Remember to use electricity safely. If water or foam touches the circuit, you must immediately cut off the power at the remote end to ensure safe production.

2. There will be air in the pipeline when it is used for the first time. The foaming liquid has not been pumped into the equipment in a short time. You can wait for tens of seconds until the liquid is filled with the entire suction tube and the foaming operation can be performed normally.

3. Do not start the equipment when the pipeline is blocked to prevent damage to the components due to overpressure in the pipeline.

Model: TR6

Maximum foam output(m3/h): 6

Motor voltage(V):220

Work rate(W): 610

Pressure(Mpa): 0.8

Pump suction(m): 1

Dimensions(cm): 600*400*400

Weight(kg): 20
<p>The development of the Russia-Ukraine conflict will continue to dominate the commodity prices such as the Foam Generator in the future. If the conflict eases or cools, Russia and Ukraine go back to negotiate, commodity prices would fall. However, if the situation between Russia and Ukraine deteriorates further, or evolves into a full-scale war, the price of the Foam Generator is predicted to see further improvement over the coming days.<br></p>

- Advertisment -

Most Popular

Recent Comments